Hot Plate Silicone Rubber Heater

Enclosure Silicone Heaters
Updated:8/12/2013 4:35:24 PM Browse:1301 Close window Print this page

Enclosure Heaters are made of wire-wound heating circuits laminated between thin layers of fiberglass-reinforced, high-temperature silicone rubber insulation. They can be stand alone, vulcanized to an aluminum mounting plate or supplied with PSA (Pressure Sensitive Adhesive). They offer safe and effective protection against problems brought on by temperature variations such as condensation. Using enclosure heaters is a cost-effective way to control temperatures and avoid replacing and repairing equipment damaged by condensing moisture. Delta Heat can work with your requirements to find a suitable unit or make custom products.


  • Standard sizes that start at 2” x 4” and increase in one inch increments to 2” x 12”
  • 115V standard, 230V available
  • Standard watt density, 5 watts per square inch
  • Comes with 36” leads standard
  • Operating temperature range of -40°F to 350°F
  • Available with built-in freeze protection thermostat in two configurations
  • Resistant to many chemical substances
  • Choice of attachment, PSA or aluminum mounting plate
  • Pre-drilled standard mounting plate
  • Horizontal or vertical mounting
  • Custom products available
On a product: Silicone Heaters

The next: Motor Silicone Heaters